omgpham…
14Jul/122

ITB Build – Part 1

FINALLY!!!!!!!!!!!!

Started pulling apart my car today, the head is being removed so I can get that ported. The AC, all wiring, intake, strut brace and fuse box will be removed to make way for my custom tucked wiring harness.

I was planning to port it myself but have decided to send it down to Warren Heath Performance down in Melbourne. The head will received an extensive porting job as well as largerĀ oversizedĀ valves, stronger valve springs and re-shimmed solid lifters. The camshaft going in will be 280degree duration and 10.5mm lift.

Didn't get too much done today but photos below.


The operating table where most of the work will be done.



Bonnet off, radiator out and headers moved aside.



Valve cover off to remove the head, full port job on the way with massive cams going in.



The AC condenser removed and a pile of parts that won't be going back in.


That's all for today, covered up and put to bed.

Comments (2) Trackbacks (0)

Leave a comment

No trackbacks yet.