Custom Wiring Harness – Part 2

Over the last couple of days I finished off the main body harness, it's basically just wiring for the exterior lights and all in-cabin stuff plus fuses. It started out as a big mess but I think I did a pretty decent job in cleaning it up, also was able to relocate the engine bay fuse box to under the dash.

Another thing I did was remove all the stupid tape Mazda used on "wire splits" and replaced it with heat-shrink, I HATE TAPE!

I used zip ties instead of tape to bundle the wiring harness, all engine bay wiring will have convoluted tubing to protect it from stuff.

Removing the stupid tape and replacing it with heat-shrink.

Main body harness completed, now to start on the power and engine harness...

Comments (0) Trackbacks (0)

No comments yet.

Leave a comment

No trackbacks yet.