ECU Mounting

I've been dreading this part of the build, was never sure how I would do it and make it neat. But everything is coming together now and so I had to do something.

Because my custom fuse/relay panel sits where the ECU normally goes, I've had to install the ECU in the glove box. It's not a bad spot to put it, just my solution isn't "clean" for my liking.

I had to remove all the internal sides of the glove box, gives much more room for the harness to hook up. I'll also make a short serial cable "pig-tail" so I can hook up the USB connection.

All the studs were epoxied into place, not very clean and not sure if it'll be strong enough. So I might go over everything with some fibreglass, any thoughts?

Test fit was good too, but I'll let it cure overnight before I tighten up the nuts.

I also decided to use the stock tombstone, goes much better with the rest of my interior. So the KG Works tombstone will be up for sale soon.