New Parts!

Over the last week I've had a few parts cleaned up and also picked up a KG Works gauge cluster 😀

Install photos are below...

So fresh so clean clean.

Since I'm going to be using the later model cam/crank hall effect sensors, I had my NB6 valve cover blasted and powder-coated in satin black. While I was there I also had the shop blast the NB6 water neck too, this will replace the NA6 water neck because I won't be using the fan switch. Megasquirt will control the fans now.

The work was done by Global Powder Coating, price was the lowest I could find and service/turnaround was good.

First step is to remove all four screws and the steering column surround.

There are two more screws holding the gauge hood, remove those and than gently pull the hood towards the rear of the car. It should pop out with little effort.

Unplug the two connectors at the back of the cluster to remove it.

The new cluster installed 😀